Dry Ice & Blast Equipment
Electric Welding Equipment & Supplies
Flux and Chemicals
Fume Extraction Equipment
Gases, Cylinders and Dewars
Gas Equipment for Welding, Cutting, & Beverage
Welding Hand Tools
Plasma Cutting Equipment
Metal Cutting Sawing Grinding Tools
Welding Safety Equipment
Used Welding Equipment
Bulk Gas Installations
Carbin Dioxide Gas Fill Service
Welding Certification Procedures & Training
Rental Welding & Cutting Equipment
Welding Equipment Repairs
Request a Quote
Item # item-6357
Item # item-6357, The Atlas Model 1000 PipeMate
Email This Page
Save To Favorites
The Atlas PipeMate helps produce faster and cleaner welds with a minimum of manual handling and positioning.
These portable units have a low profile, 9-1/4" H x 18" L x 8" W, and a covered footswitch for on/off control, which makes them convenient and comfortable for the welder working at a shop bench, or for on-site welding.
The dual speed, Atlas PipeMate, and a non powered companion Idler Rolls unit,will support and turn properly balanced loads up to 1000 pounds. A built-in, broad spectrum, high frequency filter prevents any erratic motor speeds when Tig welding. Speed ranges can be easily changed by removing the front access panel and manually reversing the gears.
A slow 0-30 ipm or a faster 0-60 ipm final drive, is powered by a 1/15hp, 115v, AC/DC gear motor. When removing the cover to change gears, or work on the unit, there is a built-in, automatic, electrical disconnect that prevents shock. The Atlas PipeMate and Idler Rolls have two, 6" x 2" roller bearing wheels with rubber tires providing high load handling capacity, and heat and abrasion resistance. A "forward-off-reverse" selector switch; a speed control dial; and an easily accessible 2 amp fuse, for motor overload protection, are located on the front panel. The Atlas PipeMate may also be used with an Atlas Pipe Dollie as the idler roll, or with Atlas Adjustable Pipe Jacks.
Capacity: 1,000 lbs. Balanced loads with Idler Roll 500 lbs. Load bearing.
Diameter Range: 1 1/2" to 17" diameters
Dual Speed: 0-30 ipm or 0-60 ipm
Drive Motor: 1/15 hp
Power Requirement: 115 V, 50/60 Hz
Bearings: Heavy duty axle roller bearings
Motor Overload Protection: 1.5 amp fuse
Speed Control: Solid state fully variable over entire speed range
Start/Stop Control: Footswitch (on/off) with 8' cable
Construction: Heavy duty steel construction, Durable enamel finish, Two handles for easy handling
Net Weight: 60 lb
Shipping Weight: 65 lb
©2018 Sutton-Garten Co. All Rights Reserved
| Site created by
Thomas Web Solutions
and powered by